Numbering And Names Of Cylinders; End Position Sensors On The Cylinders - Hedson DRESTER GP 24 Manuel Technique

14. Numbering and names of
cylinders
3 Lid
1 Guide Rail
230756 rev 1
2 Transverse feed
4 Outside cradle
5 Inside cradle
6 Side support
15. End position sensors on the
cylinders
To set the position of the sensors the machine needs to
be turned ON with the compressed air connected. Start
Self test (see chapter 28) to move the cylinder to correct
position for the sensor that will be set.
1. Place sensor in the slot, slide it left or right until the
LED turns ON.
2. Slide sensor to the right until the LED turns OFF and
remember the location.
3. Slide sensor to the left until the LED turns OFF and
remember the location.
4. Position the sensor in the middle of the two locations
found in step 2 and 3.
EN
Location 2
Location 1
13