Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. Pressure governor
The pressure governor detects if air supply pressure
drops below 6 bar. This will cause a B-type alarm, see
alarm codes chapter 9 in the user manual. The pressure
governor must not be set to a different value, if broken
it needs to be replaced to maintain the right level of
machine safety.
pressure governor
11. Adjustment of the soft start valve
On the top of the soft start valve there is an adjusting
screw with which you can set how fast the pressure is to
rise. The screw should be tightened down completely
and then loosen 12 turns.
On the rear of the soft start valve there is a red plastic
screw. This should be positioned horizontal.
adjusting screw
12. Adjustment of the pressure
regulators
These settings should not be changed. If the regulators
aren´t working properly check the following settings:
The intake air regulator (picture below) should be set to
7.5 bars.
Note: Always decrease pressure and then increase to
wanted level.
1. Turn ON the machine. After ~10 seconds the air
pressure value is stabilized. Adjust the regulator if
necessary.
230756 rev 1
air pressure
The lid regulator for cylinder 3 should be set to 2 bars when
the lid is closed. Regulator is found on the terminal box.
Open and close four turns. (Illustrated on picture below)
red screw
If uncertain connect the calibration kit 230753 to
cylinder 3.
2. Turn OFF the machine.
3. Disconnect the hose to cylinder 3.
soft start valve
4. To connect the calibration kit, remove the red plug
and connect it as seen in the picture.
5. Turn ON the machine. After ~10 seconds the air
pressure value on the calibration kit is stabilized.
Adjust the regulator if necessary.
EN
pressure regulator
Open and then close 4 turns.
air pressure
11
Publicité
Table des Matières
