EGO Power+ ZT4200L Mode D'emploi page 32

SEAT ADJUSTMENT (Fig. 16)
WARNING: Be sure the seat is secured to the mower with the
included socket-head screws before operating the mower. A seat
that is not secure can cause the operator to lose control of the
mower and result in possible death or serious personal injury.
Adjust the seat position to ensure you are able to make firm
contact with the parking-brake pedal before operating the mower.
The seat can be adjusted forward and rearward by lifting the seat
forward-back adjustment lever under the seat.
To move the seat
1. Set the parking brake.
2. Sit down on the seat; lift the seat forward-back adjustment
lever and hold it, then move the seat forward or backward to
the desired position.
3. Release the seat forward-back adjustment lever and ensure that the seat is locked in position.
The comfort of the seat can also be adjusted with the seat-suspension adjustment knob on the underside of the seat.
Loosen or tighten the adjustment knob as indicated to achieve the most comfortable suspension.
PARKING BRAKE SETTING (Fig. 17)
The parking-brake pedal is used to lock the mower in the braking
position. To start the mower, it should be released from the braking
position.
To set the parking brake:
1. Place the steering levers back in the neutral position and open
them outwards to the park-brake position (open position).
2. Use your left foot to fully depress and hold the parking-brake
pedal until the pedal stops rebounding.
3. Release the parking-brake pedal. Remove your foot from the
parking-brake pedal.
To release the parking brake, depress the parking-brake pedal
once again; the pedal will rebound to the released position.
WARNING: Never leave the mower unattended during-work breaks without verifying that the parking brake is set
and the safety key is removed. Failure to set the parking brake could cause the mower to move. Leaving the safety key in
place may allow unauthorized use that could result in serious personal injury.
32
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200L/ZT4200L-FC
16
1
17
Braking Position Released Position
2