Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can result in serious personal injury.
APPLICATION
You may use this product for purpose listed below:
Mowing your lawn.
FINAL PREPARATION
CHECK THE TIRE PRESSURE
Check the air pressure in all tires before use. Improper air pressure will affect handling, steering response, traction, tire
life, level cutting, and operator comfort. Be sure tires are inflated to the pressure shown below.
NOTICE: Tire pressure should only be measured or adjusted when tires are cold.
Recommended Pressure
WARNING: Check the tire pressure carefully while inflating. Too much air in the tire could cause the tire to burst,
causing serious personal injury.
VERIFY MOWER CONDITION
Inspect the entire product for damaged, missing, or loose parts such as screws, nuts, bolts, caps, etc. Tighten securely all
fasteners and caps and do not operate this product until any missing or damaged parts are replaced.
TEST THE SAFETY INTERLOCK SYSTEM (Fig. 14 )
The mower incorporates a separate seat switch that will stop the
drive motors and deck motors when the operator is unseated for
any reason while the mower is operating. This is a safety feature
designed to prevent runaway or accidental entanglement. Test the
system to be sure it is working correctly.
1. Position the mower on a level surface.
2. The operator must be on the seat when testing the seat switch.
3. Release the parking brake pedal.
4. Insert the safety key into the mower and press the start/stop
button for 3 seconds to illuminate the LCD screen.
5. Pull the PTO switch upward to engage the blade motors.
6. Slowly raise yourself off of the seat, but do not get off the
mower. The deck blade system should stop.
30
56-VOLT LITHIUM-ION ELECTRIC ZERO TURN MOWER — ZT4200L/ZT4200L-FC
Front Wheel
32 PSI (222.1 kPa)
14
Rear Wheel
7 PSI (48.3 kPa)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Power+ zt4200l-fc

Table des Matières