Echo EG-10000 Manuel De L'opérateur page 34

Masquer les pouces Voir aussi pour EG-10000:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.
Notwithstanding the provisions of Subsection (4) above, warranty
services or repairs must be provided at distribution centers that are
franchised to service the subject engine/equipment.
6.
he owner must not be charged for diagnostic labor that leads to the
determination that a warranted part is in fact defective, provided that such
diagnostic work is performed at a warranty station.
7.
Rato is liable for damages to other engine/equipment components
proximately caused by a failure under warranty of any warranted part.
8.
Throughout the emissions control system's warranty period set out
in subsection (b)(2), Rato must maintain a supply of warranted parts
sufficient to meet the expected demand for such parts and must obtain
additional parts if that supply is exhausted.
9.
Manufacturer-approved replacement parts that do not increase the
exhaust or evaporative emissions of the engine or emissions control
system must be used in the performance of any warranty maintenance or
repairs and must be provided without charge to the owner. Such use will
not reduce the warranty obligations of Rato.
10. Add-on or modified parts that are not exempted by the Air Resources
Board may not be used. The use of any non-exempted add-on or
modified parts will be grounds for disallowing a warranty claim. Rato will
not be liable to warrant failures of warranted parts caused by the use of a
non-exempted add-on or modified part.
11. Rato issuing the warranty shall provide any documents that describe that
warranty procedures or policies within five working days of request by the
Executive Officer.
D - Emission Warranty Parts List for Exhaust
1.
Fuel Metering System
Carburetor and internal parts (and/or pressure regulator or fuel
injection system).
Air/fuel ratio feedback and control system.
Cold start enrichment system.
2.
Air Induction System
Controlled hot air intake system.
Intake manifold.
Air filter.
3.
Ignition System
Spark Plugs.
Magneto or electronic ignition system.
Spark advance/retard system.
4.
Exhaust Gas Recirculation (EGR) System
EGR valve body, and carburetor spacer if applicable.
EGR rate feedback and control system.
5.
Air Injection System
Air pump or pulse valve.
34
NOTES

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Eg-190628-a0000001

Table des Matières