Door Handles; Interior Light; Door Alarm; Moisture Reduction Heater - Norcold N190 Série Manuel D'utilisation

To move or remove the wire shelf of the freezer:
- Locate the plastic clip that is around the wire shelf.
- Remove and save the screw that attaches the plastic clip to
the inside of the refrigerator cabinet.
- Lift the left side of the shelf upward to remove the shelf.
- Push the wire shelf fully into the slot that you wish.
- Put the plastic clip back in the original position on the wire
shelf.
- Attach the plastic clip with the screw.
To remove or move the large shelves of the fresh food
compartment:
- Locate the plastic clip [202] that is around each wire shelf
[203] (See Art01692).
- Remove and save the screw [41] that attaches the plastic clip
to the inside of the refrigerator cabinet.
- Pull the shelf slightly forward to disengage the left side of the
shelf from the slot [157] of the refrigerator cabinet and lift the
left side of the shelf to remove the shelf.
- Put each wire shelf into the slot that you wish.
- Put the plastic clip back in the original position on each wire
shelf.
- Attach the plastic clip with the screw.
To remove the small top shelf of the fresh food compartment:
- Locate the plastic clip [202] that is around the wire shelf
[203] (See Art01692).
- Remove and save the screw [41] that attaches the plastic clip
to the inside of the refrigerator cabinet.
- Pull the shelf forward out of the slot [157].
- Put the wire shelf into the slot.
- Put the plastic clip back in the original position on the wire
shelf.
- Attach the plastic clip with the screw.

Door handles:

During travel, the door latch prevents the door from opening.
When closing each door, push the door toward the refrigerator
until you hear a "click sound.
To open each door, pull the handle away from the refrigerator
(See Art00990).
Owner's Manual 4
During storage, the storage latch prevents the door from
completely closing. Use it to prevent odors when the refrigerator
is stored for an extended period of time.
To operate the storage latch (see Art00991), open each door
about 1/2 inch, hold the door handle in the open position, and
push the storage latch [55] into the cutout [56] of the strike plate.
Do not use the storage latch as a travel latch because the doors
will not be fully closed.

Interior light:

The interior light is at the top of the fresh food compartment. It
comes on when the refrigerator is ON and the door is open. To
replace the bulb:
1. Remove the DC power supply wires from the power board at
the rear of the refrigerator.
2. To remove the cover [57] , push it toward the rear of the
refrigerator (See Art00988).
3. Remove the light bulb [58] from the holder [59].
NOTE: Use a GE#214-2 bulb or equivalent as the replacement
bulb. This bulb is available at most retail automotive
parts centers.
4. Install the replacement bulb.
5. Install the cover.
6. Connect the DC power supply wires to the power board at the
rear of the refrigerator.

Door alarm:

The refrigerator has an alarm to alert you if the fresh food
compartment door is not closed. The refrigerator continues to
operate, but if the fresh food compartment door is open and the
interior light remains on for two minutes:
- An audible alarm starts.
- "dr" appears in the center display.
- The interior light automatically turns off.
Close the door to silence the alarm.

Moisture reduction heater:

The refrigerator has a heater that prevents moisture from forming
on the center divider between the doors of the freezer and the
fresh food compartment. The heater operates only when the
refrigerator is ON and the DC power is sufficient.