Maintenance And Cleaning - Whirlpool SDD 534 U Manuel D'instructions

Do not turn off the dishwasher while water is still in the tank. Always drain it first. When finished using the
machine, after having performed the final drainage and eventual regeneration, turn the machine off by pressing
the on/off
machine on, inactive and unutilized for long periods of time.
Even though the dishwasher does not require any special programmed maintenance in particular, we still recommend you have
it checked out by a specialized technician twice a year.
N.B: The manufacturer cannot be held liable for intentional damages or damages caused by carelessness, negligence or from
the failed observance of the prescriptions, instructions and standards or from incorrect connections or plumbing.
The dishwasher complies with the protection rating IPX1 and it is forbidden to use a direct jet of water to clean it.
CLEANING THE FILTER THROUGHOUT THE DAY
For heavy use, you are recommended to clean the filter every 30-40 cycles while the machine is in working conditions. To do
this, follow the "emptying the tank" instructions.
Remove the filter (1) (simply lift it out of its seat as illustrated), making sure large bits and pieces do not fall into the tank; clean
the filter and rinse it thoroughly.
Also clean the internal filter (2) and remove any bits and pieces inside it.
Put the filter back into its seat correctly (1). Do not use pointed or sharp tools to do this.
Clean away any scale to avoid possible build-up. Clean the surface carefully and frequently using a damp cloth. Use neutral and
non-abrasive detergents that do not contain chlorine-based substances or products that could corrode and damage stainless
steel.
Do not use the afore-mentioned products to clean the floor under the dishwasher either, or even near it, in order to prevent
vapours or drips from causing damage to the steel surface.
To clean the tank and the walls, you are recommended to use a damp cloth or a shammy leather cloth, with soapy water and a
mild detergent. Never user scouring pads or metal sponges.
Periodic checks
Disassemble the spray arms (bottom and top 2-3), by unscrewing the central screw (1).
Clean the holes and the nozzles under clean running water, do not use any pointed or sharp tools that could damage them. Fit
the spray arms back in place.
Clean the machine internally using a damp cloth and neutral detergent then rinse and dry thoroughly.
button, deactivate the wall switch and turn off the water interception faucet. Do not leave the
6 – MAINTENANCE AND CLEANING
close the door and press the on/off key
machine down at the end of the day, switch off the wall switch and
close the water inlet tap.
. In order to shut the
26