Removing The Refrigerator Doors - Samsung RF261B Série Guide D'utilisation

FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support
a fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull
and push it straight forwards or back.
Do not wiggle it from side to side.
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Hex wrench
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips Flat-blade screw
screwdriver(+)
Pliers
(3/16") (5mm)
DA68-02601B-09.indb 7
Fastener
Socket wrench
driver(-) (10mm)
Allen wrench
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don't need to. If you do
not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
Disconnect power to the refrigerator before
removing the door or drawer.
WARNING
• Be careful not to drop, damage or
scratch the door/drawer while removing
them.
• Use care when remove the doors/drawer.
The doors are heavy and you could injure
yourself.
• Reattach the doors/drawer properly to avoid:
- Moisture from air leakage.
- Uneven door alignment.
- Wasting energy due to improper door seal.
HOW TO ASSEMBLE THE HANDLE
Fridge door handle assembly
Check the direction of Handle assembly.
(Assemble the side of the handle attached a
sticker toward toward the upper direction.)
English - 7
2014. 2. 4. 2:39