Removing The Refrigerator Doors - Samsung RF26HF Serie Manuel D'utilisation

When moving your refrigerator
To prevent floor damage, be sure the front
adjusting legs are in the up position (above
CAUTION
the floor). Refer to 'Adjusting the Level' in
the manual (on page 22).
For safety reasons, adjust the front side a
little higher than the rear side.
Flat-blade screw
Control Lever
driver(-)
Both control levers must be touching the floor to
avoid possible personal injury or property damage
because of tipping.
FLOORING
For proper installation, you must place this
refrigerator on a level, hard surface that is the
same height as the rest of the floor.
This surface should be strong enough to support
a fully loaded refrigerator.
To protect the finish of the flooring, cut a large
section of the cardboard carton and place it under
the refrigerator where you are working.
When moving the refrigerator, you need to pull
and push it straight forwards or back.
Do not wiggle it from side to side.
DA68-02601N-00.indb 18
ACCESSORIES AND
REQUIRED TOOLS
The following accessories are included with your
refrigerator:
Compression Nut (1/4")
Required Tools (Not provided)
You need the following tools to complete the
installation of your refrigerator:
Philips Flat-blade screw
screwdriver(+)
Allen wrench
(5 mm)
REMOVING THE
REFRIGERATOR DOORS
For some installations you need to remove the
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don't need to. If you do
not need to remove the refrigerator doors, go to
Adjusting the Level on page 22. If you need to
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:
English - 18
Compression Fitting
Socket wrench
driver(-) (10 mm)
2017. 1. 23. 3:08