Philips AVENT Premium SCD841 Mode D'emploi page 32

32
English
OPERATING TIME / RANGE
The operating time
of the parent unit is
supposed to be up
to 10 hours. Why is the
operating time of my
parent unit shorter?
VIDEO DISPLAY
Question
Why do I get
interference on the
parent unit? Why does
the video display on the
parent unit flicker?
Why isn't there any
image on the video
display while the
link light is green?
Why isn't the image on
the video display clear?
The video brightness of the parent unit may be set too high, which causes
the parent unit to consume a lot of energy. Decrease the brightness of the
parent unit.
The parent unit consumes a lot of energy when the video display is
switched on continuously. Activate the AUDIO, VOX or ECO mode in the
parent unit's menu to increase the operating time (see chapter 'Features',
sections 'AUDIO mode', 'VOX mode' or ' ECO mode' ).
The volume of the parent unit may be set too high, which causes the parent
unit to consume a lot of energy. Decrease the volume of the parent unit.
As any other rechargeable electronic device, the battery capacity decreases
after a long period of usage.
Answer
Interference may occur when the parent unit is out of range of the baby
unit. Interference may also occur if there are too many walls or ceilings
between the parent unit and the baby unit or when other 2.4 GHz wireless
devices are switched on (e.g. microwave, Wi-Fi router).
Perhaps you have more than 2 sets of baby monitors and interference may
occur. Keep these 2 baby units away from each other, ideally in separate
rooms.
Put the parent unit in a different place, closer to the baby unit, or switch off
other wireless devices.
The rechargeable battery of the parent unit may need to be charged.
The parent unit may be in the AUDIO, VOX or ECO mode. Press the mode
button on the right side of the parent unit to switch modes (see 'Modes').
The display brightness may be set too low. Increase the display brightness
on the parent unit using the control button in the centre (see 'Brightness').
Perhaps the lens of the baby unit is dirty. Clean the lens with a dry cloth.
The baby unit may be too far away from your baby. Make sure the baby unit
is not further than 1.5 meters / 5 feet away from your baby for optimal video
quality. Closer than 1 meter / 3.5 feet increases strangulation hazard.