Beta 588 Mode D'emploi page 5

INSTRUCTIONS FOR USE
Installation and Operation Guide for Screwdriver TruCheck Plus
INSTALLATION
1. Identify a suitable surface and position to mount the instrument.
2. Using the template on this guide, mark the position of the 2 mounting holes.
3. Drill (or drill and tap) the 2 mounting holes suitable for 6 mm fasteners (M6; Grade
8.8 minimum; cap head type are recommended or the equivalent).
4. Fix instrument in position using fasteners at a torque of 7.3 to 8.4 N.m (5.4 to 6.2 ft.lb).
5. Connect power supply (supplied) to the instrument. All display segments will light and buzzer will sound
briefly. The instrument is ready for use.
WARNINGS
• ENSURE THE MOUNTING SURFACE IS CAPABLE OF SUPPORTING THE INSTRUMENT WHEN THE RATED
CAPACITY TORQUE IS APPLIED.
• ONLY USE THE POWER SUPPLY PROVIDED.
• DO NOT APPLY TORQUE ABOVE THE RATED CAPACITY.
OPERATION
MODE Button
1. Press MODE button briefly to display current mode of operation.
2. Press and hold MODE button to change mode of operation. Release button at required mode to accept.
3. Modes of operation.
• Track Mode ('trAC' is displayed).
Display follows torque applied
• Click Mode ('CLIC' is displayed).
Display shows first peak of torque applied. Serial data output of peak torque is automatically transmitted.
Display automatically resets after 3 seconds.
For use with 'click' type torque wrenches.
• Dial Mode ('dIAL' is displayed).
Display shows peak of torque applied. Press RESET to clear the display.
For use with 'dial' and 'electronic' type torque wrenches.
UNIT Button
Press UNIT to change units of measurement.
RESET Button
Press RESET to reset display in Dial mode. Serial data output of peak torque is also transmitted.
Press RESET to transmit serial data in Track mode.
LIMIT Button
1. Press LIMIT to enter target torque setting.
Display flashes between 'SEt' and the target torque setting.
• Press MODE to increase target setting. Hold to increase speed of change.
• Press UNIT to decrease target setting. Hold to increase speed of change.
2. Press LIMIT to enter ± percentage tolerance setting from 1 to 10%. Enter '0' for no limits.
'%' and the ± percentage tolerance setting is displayed constantly.
• Press MODE to increase ± percentage tolerance setting.
• Press UNIT to decrease ± percentage tolerance setting.
3. Press LIMIT to finish. Display shows 'FIN' for 1 second.
Using the Instrument
1. Select mode of operation.
2. Place screwdriver / wrench in the instrument and operate in desired direction. Remove screwdriver / wrench and zero
the display (if required) by pressing the RESET and LIMIT buttons together. 'SEt0' is displayed for 1 second.
3. Place screwdriver / wrench in the instrument and operate in desired direction.
Serial Port.
Connect lead (supplied) between TruCheck Plus serial port and computer/ printer.
Communication settings: 9600 Baud, 8 data bits, 1 stop bit, no parity.
DO NOT APPLY TORQUE ABOVE THE RATED CAPACITY
EN
5