Installation On Your Bike; Installing The Device - Pioneer SGX-CA500 Mode D'emploi

Installation on Your Bike

EN
Mount the Cyclocomputer on your bike.
Caution
• When you mount the Cyclocomputer on your bike, be sure
your bike is in a stable position to prevent it from falling.

Installing the Device

1
Remove the bolt from the bracket.
Remove the bolt from the bracket using a 3 mm hex
wrench.
hex wrench
• Be careful not to lose the removed bolt.
2
Mount the bracket on the handlebar of your
bike.
• Be careful not to pinch your finger when mounting the
bracket on the bike.
3
Secure the bracket with the bolt.
Apply an anti-seize compound like grease to the bolt.
Adjust the bracket horizontally from the stem, insert the
bolt into the hole and tighten lightly.
8
4
Check the position of the fixed lever on the
bracket.
Check the red circle on the right side of the fixed lever. If
you do not see it, the device cannot be attached.
If the red circle is hidden, push the fixed lever into the
right.
When the fixed lever is on this position,
the bracket can be mounted.
Fixed lever
5
Attach the strap to the device.
Lace the strap through the strap holes in the device.
6
Attach the device to the bracket.
Fasten the strap to the handlebars. Set the tip of the
bracket in the bracket slot on the device and push the
device until it clicks.