Pioneer SGX-CA500 Mode D'emploi page 47

Calibrating the Touch Panel
Use the procedure below to calibrate the touch panel to
ensure correct response when you touch the screen with
your finger.
1
On the home screen, tap the [Settings] icon.
2
Tap [System] - [Display] - [Touchscreen
Calibration].
This displays the touch panel calibration screen, with a
cross mark on it.
3
Tap the center of the cross mark.
This causes another cross mark to appear. Tap the
center of the next cross mark. A total of five cross marks
appear on the screen.
4
Tap all four square marks within 30 seconds.
Touch panel calibration will be completed after tapping
the four square marks within the allowed time.
After the message "Calibration completed." appears, tap
[OK].
Touch panel calibration will be exited if you do not tap it
within the allowed time.
Cyclocomputer Settings
47
EN