Initialize - Pioneer SGX-CA500 Mode D'emploi

Initialize

Initialize returns the device system and application settings
to their initial factory defaults.
• If the device is connected to a PC with the USB cable,
disconnect the USB cable from the PC before initializing. If
the device is logging, stop logging and save the log data.
• Initializing the device will cause all system data to be lost.
Backup of data is recommended prior to initialization.
Also note that initialization deletes backup data stored in
device flash memory. Before initialization, be sure to move
backup data to a PC or other media storage device.
Ü Backup (page 54)
1
On the home screen, tap the [Settings] icon.
This displays the settings menu.
2
Tap [System] - [Setting Manager] - [Initialize].
This will display a confirmation message asking if you
want to initialize system data.
3
Tap [OK].
This starts system data initialization.
The message will appear when initialization is complete
and the device restarts automatically.
• After the device restarts, the Initial Setup screen will appear.
Configure initial settings.
Ü Initial Setup (page 12)
Initialized, Backed Up, and Restored Data
The table below shows what settings are affected by
initialize, backup, and restore operations.
Description
Home screen Shortcut icon
settings arrangement
Cyclocomputer Date/Time
Settings
Touchscreen
Calibration
Settings other than
those above.
CycloMeter settings
CycloMeter riding log
EN
Initialize Backup/
Restore
○ ○
‒ ‒
‒ ○
○ ○
○ ○
○ ‒
53