Philips arcitec RQ1090 Mode D'emploi page 20

English
22
2 Why doesn't the shaver work when I press the
on/off button?
- The battery may be empty. Recharge the battery
(see chapter 'Charging').
- The travel lock may be activated. Press the on/off
button for 3 seconds to deactivate the travel lock.
- The shaving unit is soiled or damaged to such an
extent that the motor cannot run. In this case,
the shaving unit symbol, the tap symbol and
the exclamation mark flash. When this happens,
you have to clean the shaving unit or replace it.
Immerse the shaving unit in hot water with some
liquid soap.
- The temperature of the shaver may be too high.
In this case, the shaver does not work and the
exclamation mark on the display flashes. As soon
as the temperature of the shaver has dropped
sufficiently, you can switch on the shaver again.
3 Why is the shaver not fully charged after I
charged it in the charger/Power Pod?
- You may not have placed the shaver in the
charger/Power Pod properly. Make sure you press
the shaver until it locks into place.