König Electronic SEC-TRANS60 Mode D'emploi page 11

Alarm
When PIR detection is set to on, the system will give an alarm when motion is detected.
1. Select alarm in the main menu and press OK.
2. The screen shows PIR detection, press OK.
3. Press "On" or "Off" with the up and down arrow button.
4. Press OK to confirm and exit.
Live view:
Press the quarter display button to select the type of view.
Time stamp
Quad view
Note: use the left and right arrow button to select a camera
Press the display mode button to enter cyclic mode view. Five cyclic intervals are available: 5s, 10s, 15s, 20s, and 30s
and can be set under "System" > Scan Mode Period in the mean menu.
Picture in picture view
Mobile hard disk inserted successfully
SD card inserted successfully
Camera name
11
Full screen view