Domo DO335A Mode D'emploi page 30

DO335A
EACH MODE WORKING PRINCIPLE
1. Automatic mode
Once the automatic operation is selected, the indoor temperature sensor operates
automatically to select the desired operation mode with cool or fan.
When the room temperature is the same or higher than 24°C, the unit will
automatically select cool mode and the fan will turn to low speed.
When the room temperature is lower than 24°C, the unit will automatically select fan
mode and the fan will turn to low speed.
2. Dehumidifying mode
The fan will run at low speed and the speed can't be adjusted.
The compressor and the outdoor centrifgal fan will stop after running 8 min., then run
again after 6 min.
The unit adopts constant temperatur dehumidifying mode, and adjustment of the
temperature is not effective.
3. Cooling mode
When the room temperature is higher than set temperature, the compressor starts to
run.
When the room temperatur is lower than set temperature, the compressor stops and
only the fan will operate at original set speed.
4. Fan mode
The fan runs at set speed, and the compressor and compressor does not run.
The adjustment of the temperature is not effective.
5.Timer operation
Press „timer" button to set automatic off time whie the unit is running.
Press „timer" button to set automatic on time while the unit is ready.
The time can be adjusted within a range of 1 hour to 12 hour Press the temp up or
temp down button to increase or decrease.
6. Swing operation
Press swing button to change the air fl ow direction within a range of 0 to 120°.
The unit's default setting is the straight direction.
7. Sleep operation
The slee operaton is effective when the unit is under cool mode.
Press the sleep button in cool mode, then the unit will work under sleep mode and the
fan will turn to low speed automatically. The set temperature will increase 1°C after
1 hour. And it will increase 2°C after two hours. After six hours, the unit will stop
running.
30