DOMUS LINE EVOATOM TEBE Manuel D'installation page 5

INSTALLATION MANUAL
WARNINGS
Safety is guaranteed if these instructions are followed and therefore
they must be kept. Installation may require qualified personnel to be
involved. Before proceeding with installation of the device ensure that
the environmental conditions are in compliance with and suitable for
the product characteristics. Before any operation on the device remove
mains power.
INSTALLATION EVOATOM (fig.1,2,3,4):
INSTALLATION TEBE (fig.3,4,5,6):
- Fasten the metallic bracket (A) with the included screws (B) as
illustrated in figure.
- Insert the light (C) into the hole in the metallic bracket, taking care that
the springs (D) are not aligned with the discharge (E) and that the cable
(F) is on the opposite side of the bracket (G) as illustrated in figure.
- Anchoring of the light to the metallic bracket must be carried out
inserting first one spring and then the other, applying slight pressure
until completely fitted as illustrated in figure 3.
- Lastly, stretch out the cable and fasten it to the installation surface with
the cable tie (H) and the screws (I) included as illustrated in figure 4.
CONNECTING THE DEVICE TO THE POWER SUPPLY _ static light
configuration for all device
- Connect the device power cable to an appropriate (check plate data
printed on the product label) safe power supply with stabilised voltage
(not included) with power 10% higher than the total load.
- If more than one device must be connected to the power supply
ensure that the total sum of the power absorbed by the devices (check
the plate data shown on the product label) does not exceed the
maximum power permitted by the Converter.
EN
CONNECTING THE DEVICE TO THE POWER SUPPLY _ Tunable White
dynamic light configuration (fig.7)
- Connect the EVOATOM-TEBE TW power supply cable to one of the
light colour dynamic adjustment systems (for example MAGIC TUNE,
TOUCH TW, X-DRIVER TW etc., sold separately) and with power at least
10% greater than the total load. For the total load calculation check
plate data printed on the product label.
- For installation and operation of the light colour dynamic adjustment
system see the specific item's manual.
- Then connect the light colour dynamic adjustment system to a safe
power supply with 24Vdc stabilised voltage (sold separately) and with
power at least 10% higher than the total load. For the total load
calculation check plate data printed on the product label.
- If more than one device must be connected to the power supply unit
ensure that the total sum of the power absorbed by the devices (check
the plate data shown on the product label) does not exceed the
maximum power permitted both by the dynamic adjustment system
and by the Converter.
WARNING
- The LED module of these devices is not replaceable.
- The external flexible cable is not replaceable.
- In case of failure it must be entirely replaced the entire unit.
WARRANTY
DOMUS Line guarantees the product only if powered with Converters
and dynamic light adjustment systems supplied by us.
The warranty general terms and conditions for this device are available
at www.domusline.com