Publicité
Les langues disponibles
Les langues disponibles
3.11. Modification of the appliance. Any modification must be written authorized by
Manufacturas Rocal SA. It is strongly recommended to use original spare pieces provided by
Manufacturas Rocal SA.
4. TROUBLESHOOTING
This is a table with potentials problems, the reason for them and solutions:
PROBLEM
REASON
1. Smoke leaking
Incorrect flue draught
into the rrom /
insufficient
flue
draght
Gate valve
2. Excessively
Incorrect flue draught
dirty glass
Poor quality fuel
Air slider not open enough
3. Appliance
Poor quality fuel
produces few
heat
Dirty inner walls of the appliance
Incorrect external air intake
Low water pressure
Air in hydraulic circuit
4. Appliance
Firsts ignitions
emitting smoke /
producing bad
Flammable or combustible elements in the zone or
walls surrounding the appliance
Crack in the combustion chamber of the appliance
5. Boiling makes
Lack of water in the circuit
noise
There is no electricity in the home
The circulation pump is blocked
Excess fuel
The inspection of the appliance and the installation must be carried out by a Professional.
For any doubt consult your local Rocal dealer.
SOLUTION
- Check that flue draught
- Connection – diameter – leak on this way
- Insufficient length
- Exit to the outside
- Any elements to obstruct the exit
Unlock gate valve
Check the flue draught
Use authorized fuel
Check the air slider position
Use authorized fuel
Cleaning with a wire brush and a metal spatula.
Check the flue draught and diameter (if it's necessary).
Adjust the pressure of the hydraulic circuit
Purge the installation of the hydraulic circuit
Ventilate the room and wait for the paint to cure. This
could take several uses
Check insulation material (glassfibre, igneous wood or
other elements) , if possibly replace them
Call dealer or Professional.
Add water in the hydraulic circuit. No refuel
Check electric power. No refuel
Call a Professional. No refuel
Reduce fuel load
Publicité
