Getting Started - Altec Lansing Mix iMT800 Guide D'utilisation

Getting Started

How to install the Ac Adapter
1
Connect the AC adapter cable plug
into the speaker system's jack.
The jack is located on the back of
the system.
2
Plug the AC adapter into the
wall outlet.
How to install the Speaker Batteries
Your Altec Lansing Mix speaker system can also be powered by 8 D-size
(LR20) batteries (not included). To install the batteries, follow the steps below:
1
Make sure that there is no iPhone
or iPod in the system's dock
and that no other devices are
connected to the system.
2
Unplug the AC adapter from the
Mix speaker system.
3
Open the battery compartment.
The battery door is located on the bottom of the Mix speaker system.
To access it, place the unit on its back, so that the speakers are
facing the ceiling. Then simply pull the tabs to open the battery
compartment.
Caution: Do not place the unit on its top side. This may damage the
volume knob.
4
Install 8 D-size (LR20) batteries (not included) in the battery
compartment.
Make sure the batteries are correctly installed as illustrated in the
battery compartment. The batteries will provide up to 30 hours of
continuous playing time.
4
5
Replace the battery door.
Please discard used batteries properly.
NoTe
NoTe When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off to conserve
electricity.
How to install the clip-on remote Battery
The clip-on remote battery (included) is not installed at the factory. To install
the battery, follow the steps below. The battery compartment is at the back
of the remote. Push the battery compartment door in the direction of the
arrow to unlock it.
1
Open the battery door.
The battery door is located on the back
of the remote. Using your thumb, push
the battery door toward the carabiner
clip. Then lift the battery door open.
2
Position the battery (included) so it
sits in the battery holder correctly.
Make sure the polarity (the + and – sides of the battery) is correct.
3
Replace the battery door.
NoTe Please discard used batteries properly.