Altec Lansing Mix iMT800 Guide D'utilisation page 21

Symptom Possible Problem
iPhone or iPod is not installed properly.
Your iPhone or iPod software is too old.
iPhone or iPod
doesn't respond to
the speaker system
iPhone or iPod is locked up.
Using 1st- or 2nd-generation iPod, iPod
shuffle or other devices.
iPhone or iPod is not installed properly.
iPhone or iPod is locked up.
iPhone or iPod didn't charge
AC adapter isn't plugged into a wall outlet,
or the connector is not plugged into the
power supply jack on the back of the
speaker system.
Solution
Remove your iPhone or iPod from the dock and check for obstructions on
the connectors in the dock and on your iPhone or iPod. Then reseat it in the
dock and slide the guard down to protect it.
Upgrade software on your iPhone or iPod. For details visit
www.apple.com/ipod/download.
Please make sure your iPhone or iPod is working properly before docking into
the unit. Please refer to your iPhone or iPod manual for details.
Your speaker system cannot control those iPods or other devices.
Remove your iPhone or iPod from the dock and check for obstructions on the
connectors in the dock and on your iPhone or iPod. Then reseat it in the dock
and slide the guard down to protect it.
Please make sure your iPhone or iPod is working properly before docking into
the unit. Please refer to your iPhone or iPod manual for details.
Plug the AC adapter into a wall outlet and plug the connector into the supply
jack on the speaker system. The iPhone or iPod will not charge when the
speaker system is operating on batteries.
Troubleshooting
19