Setting Eq Controls - Altec Lansing Mix iMT800 Guide D'utilisation

How to Set the Bass and Treble control Using the onboard controls
1
Access the bass and treble settings.
Press the "EQ" button once. The Bass Control screen will appear on
the LCD.
2
Increase or decrease the bass level.
Rotate the knob.
3
enter the Treble Control screen.
Press the EQ button again. The Treble Control screen will appear.
4
Increase or decrease the treble level.
Rotate the knob.
5
exit the Treble Control screen.
Press the "EQ" button again. Or the unit will automatically exit this
screen after a few seconds.
How to Set the Bass and Treble control Using the clip-on remote
1
Access the bass and treble settings.
Press the "EQ" button once. The Bass Control screen will appear on
the LCD.
2
Increase or decrease the bass level.
Press the "+" or "–" buttons.
3
enter the Treble Control screen.
Press the "EQ" button again. The Treble Control screen will appear.
4
Increase or decrease the treble level.
Press the "+" or "–" buttons.
5
exit the Treble Control screen.
Press the "EQ" button again. Or the unit will automatically exit this
screen after a few seconds.
How to change the eQ Presets Using the onboard controls
1
Access the eQ presets.
Press and hold the "EQ" button for approximately 3 seconds.
2
Select your desired preset.
Press the or buttons to cycle through the four EQ presets.
Presets include: 1) ALTEC EQ, 2) ROCK, 3) HIP HOP, and 4) POP.
3
exit the eQ Preset screen.
Press the "EQ" button again. Or the unit will automatically exit this
screen after a few seconds.
NoTe: To reset the EQ Presets to factory settings, press and hold the EQ
button for a few seconds.
How to change the eQ Presets Using the clip-on remote
1
Access the eQ presets.
Press and hold the "EQ" button for approximately 3 seconds.
2
Select your desired preset.
Press the or buttons to cycle through the four EQ presets.
Presets include: 1) ALTEC EQ, 2) ROCK, 3) HIP HOP, and 4) POP. Or,
press P1 for ALTEC EQ, P2 for ROCK, P3 for HIP HOP or P4 for POP.
3
exit the eQ Preset screen.
Press the "EQ" button again. Or the unit will automatically exit this
screen after a few seconds.

Setting eQ Controls

13