Table des Matières
Publicité
ENGLISH
2.4) Head rotation
For ease of operation, the tool head can rotate through 180°.
Warning: do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.5) Blade retraction
By pressing the pressure release button (17), the ram (06) and the lower blade will retract.
2.6) Battery status
(Ref. to Fig. 1)
After releasing the operation push-button, the residual battery capacity is automatically dis-
played, for 5 seconds. The number of Led's illuminated indicates the residual capacity:
8 led's illuminated: fully charged
4 led's illuminated: 50% capacity
1 led illuminated: minimum charge
When replacing the battery press the two points marked with the word "PUSH" at the same
time, remove the battery from its housing and insert the new one.
2.7) Power from an external source
Using the integral socket (26) the tool can operate from a external power supply (min. 20A)
or vehicle battery.
Using the special connection cable type ESC 600, supplied as an optional accessory, pro-
ceed as follows:
– Make sure the feed voltage is between 12 and 14,4 V DC.
– Connect the end with the spring grips to the external supply making sure to comply with
the polarity: the red grips to the positive pole (+), the black to the negative pole (–).
– Remove the cap (25) and connect the other end of the connection cable (93) to the socket
(26) of the tool; tighten the connector (92) by turning the ring nut clockwise until it locks.
– When the work is fi nished, disconnect the connection cable (93) and replace the protective
cap (25).
Should the poles be accidentally reversed, the tool will not be damaged but will operate
using only the integral battery (20). For rectifi cation, reverse the polarity of the grips.
W
HEN OPERATING USING POWER SUPPLY FROM AN EXTERNAL SOURCE
CIRCUIT THE METAL CONTACTS INSIDE THE BATTERY HOUSING
(20)
THE BATTERY
IN ITS HOUSING
.
EXTERNAL SOURCE
(Ref. to Fig. 2)
,
NEVER SHORT
,
WE ADVISE LEAVING
,
IT WILL SUPPLY POWER IN PARALLEL WITH THE
03
02
08
04
14
40
FIG. 5 LOWER BLADE REPLACEMENT - CHANGEMENT LAME INFERIEURE
SCHNEIDMESSER WECHSEL - CAMBIO CUCHILLA INFERIOR
CAMBIO LAMA INFERIORE
6
35
FIG. 4
UPPER BLADE REPLACEMENT
CHANGEMENT LAME SUPERIEURE
GEGENMESSER WECHSEL
09
CAMBIO CUCHILLA SUPERIOR
03
CAMBIO LAMA SUPERIORE
02
11
13
14
40
16
41
06
04
Publicité
Table des Matières
