Drain Facility; Location Considerations; Alcove Or Closet Installation - Samsung WA45T3400 Série Manuel D'utilisation

The water faucets must be within 4 feet
(122 cm) to the back of your Washer to
match the inlet hoses provided with your
Washer.
NOTE
Accessory inlet hoses are available in
various lengths up to 10 feet (275 cm) for
faucets that are further away from the back
of your washer.
To avoid the possibility of water damage:
• Have water faucets easily accessible.
• Turn off faucets when the washer is not
in use.
Periodically check that there is no
•
leakage from the water inlet hose
fittings.
WARNING
Check all connections at the water valve and
faucet for leaks

Drain facility

The recommended height of the standpipe
is 39 in (99 cm). The drain hose must be
routed through the drain hose clip to the
standpipe. The standpipe must be large
enough to accept the outside diameter of
the drain hose. The drain hose is attached to
the washer at the factory.
Flooring
For best performance, you must install
your washer on a solidly constructed floor.
Wood floors may need to be reinforced to
minimize vibration and/or unbalanced load
situations. Carpeting and soft tile surfaces
are contributing factors to vibration which
can cause your washer to move slightly
during the spin cycle.
WA3400T_DC68-03850E-01_EN.indd 17
Never install your washer on a platform or
weakly supported structure.

Location considerations

Do not install your washer in areas where
water may freeze, since your washer will
always retain some water in its water valve,
pump, and hose areas. Frozen water can
damage the belts, the pump, hoses, and
other components.

Alcove or closet installation

Minimum clearances for closet and alcove
installations:
1 in /
Sides
25 mm
5.9 in /
Rear
150 mm
If the washer and dryer are installed
together, the closet front must have at least
a 72 in² (465 cm²) unobstructed air opening.
Your washer alone does not require a
specific air opening.
Closet 1 in /
front 25 mm
21 in /
Top
533 mm
English 17
2020-07-07 PM 4:15:52