Water; Drain Facility - Samsung WF501AN Serie Manuel D'utilisation

BASIC LOCATION REQUIREMENTS
Electrical
• 120 Volt 60 Hz 15 AMP fuse or circuit breaker
• Individual branch circuit serving only your Washer is recommended.
• Your Washer is equipped with a power cord.
NEVER USE AN EXTENSION CORD.
CAUTION
Grounding
ELECTRICAL GROUNDING IS REQUIRED FOR THIS APPLIANCE.
This appliance must be grounded. In the event of malfunction or breakdown, grounding will
reduce the risk of electric shock by providing a path of least resistance for electric current.
This appliance is equipped with a power cord having a three-prong grounding plug for use in a
properly installed and grounded three-prong outlet.
An improperly connected equipment-grounding conductor can increase the risk of electrical
shock. Check with a qualifi ed electrician or serviceman if you are not sure whether the
WARNING
appliance is properly grounded. Do not modify the plug provided with the appliance – if it
does not fi t the outlet, have a proper outlet installed by a qualifi ed electrician.
IMPORTANT SAFETY PRECAUTIONS
• To prevent unnecessary risk of fi re, electrical shock or personal injury, all wiring and
grounding must be done in accordance with the National Electrical Code ANSI/FNPA, No.
70 Latest Revision and local codes and ordinances. It is the personal responsibility of the
appliance owner to provide adequate electrical service for this appliance.
NEVER CONNECT THE GROUND WIRE TO PLASTIC PLUMBING LINES, GAS LINES, OR
HOT WATER PIPES.
CAUTION

Water

To correctly fi ll your Washer in the proper amount of time, water pressure of 20 to 116psi (137
to 800kPa) is required. Water pressure less than 20 psi may cause water valve failure, may not
allow the water valve to shut off completely, or may extend the fi ll time beyond what your washer
controls allow, causing your washer turning off. A time limit is built into the controls to prevent
extensive fl ooding in your home if an internal hose becomes loose.
The water faucets must be within 4 feet/122cm of the back of your washer to match the inlet
hoses provided with your Washer.
Accessory inlet hoses are available in various lengths up to 10 feet/305cm for faucets that
are further away from the back of your washer.
To avoid the possibility of water damage:
•
•
•
CHECK ALL CONNECTIONS AT THE WATER VALVE AND FAUCET FOR LEAKS.
WARNING

Drain facility

The recommended height of the standpipe is 18 in/46 cm. The drain hose must be routed
through the drain hose clip to the standpipe. The standpipe must be large enough to accept the
outside diameter of the drain hose. The drain hose is attached at the factory.
WF501ANW-03010B_EN.indd Sec3:13 WF501ANW-03010B_EN.indd Sec3:13
Have water faucets easily accessible
Turn off faucets when the washer is not in use.
Periodically check that there is no leakage from the water inlet hose fi ttings.
installing your washer _13
2011-06-30 2011-06-30 4:05:27 4:05:27