Philips 8200 Série Mode D'emploi page 25

4222.002.4998.2.indd 27
and refill the cleaning chamber (see chapter
'Cleaning and maintenance').
- The shaving heads may be damaged or worn.
Replace the shaving heads (see chapter
'Replacement').
- Long hairs may be obstructing the shaving heads.
Clean the cutters and guards with the brush
supplied (see chapter 'Cleaning and maintenance').
2 The shaver does not work when I press the
on/off button.
- The battery may be empty. Recharge the battery
(see chapter 'Charging') or connect the shaver to
the mains.
- The travel lock may be activated. Press the on/off
button for 4 seconds to deactivate the travel lock.
- The temperature of the shaver may be too high.
In this case, the shaver does not work. As soon
as the temperature of the shaver has dropped
sufficiently, you can switch on the shaver again.
3 The shaver is not entirely clean after I clean it
in the Jet Clean System.
- The cleaning fluid in the cleaning chamber may be
soiled. Empty and rinse the cleaning chamber.
- The cleaning fluid level may be too low. If the
fluid volume in the cleaning chamber drops
below the minimum level during the cleaning
program, the program aborts.The cleaning symbol
and the 'fluid low' symbol flash at intervals and
the holder returns to its starting position. Refill
the cleaning chamber with cleaning fluid up to
the MAX indication (see chapter 'Cleaning and
maintenance').
- You may have used another cleaning fluid than
the original Philips cleaning fluid. Only use HQ200
cleaning fluid.
ENGLISH
27
27-02-2009 11:34:47