Carpet Height Adjustment; Select Proper Tool; Removing Hose; Tools - Hoover UH30300 Guide D'utilisation

carpet heiGht adJustMent

2.6
Tools allow for cleaning surfaces above the floor
and for reaching hard to clean areas.
The vacuum is ready for tool use when handle is in
upright position.
On models with "Suction Only Mode", always place
vacuum in "Suction Only Mode" for tool use.

select proper tool

(Tools may vary per model)
3.1
A
C

reMoVinG hose

3.2
A

3. tools

b
D
3.2 To remove Hose for
tool use, press the
Hose Release Button
and pull Hose end out.
To lock back into place,
push Hose into Hose
Tube until you hear a
click.
2.6 To adjust Height setting, PUSH DOWN and
TURN knob (A) to desired setting.
For maximum cleaning performance, the following
carpet height settings are recommended:
• Lowest setting: for all types of carpet and
bare floors.
• Higher settings: for very deep pile carpet,
where easier pushing effort is desired, while
maintaining good cleaning performance.

IMPORTANT

If the vacuum is difficult to push, push down and
turn knob to the next higher setting.
IMPORTANT
Brushroll continues to turn while product is
turned on and handle is in upright position unless
vacuum is in "Suction Only Mode" (available on
select models only. To avoid damage to carpet,
rugs, furniture and flooring, avoid tipping cleaner
or setting it on furniture, fringed area rugs, or
carpeted stairs during tool use.
A. Use Upholstery Tool to clean upholstered
furniture, draperies, mattresses, clothing, and
carpeted stairs. (Tool varies per model)
B. Powered Hand Tool may be used for upholstered
furniture, draperies, mattresses, clothing, automobile
interiors, and carpeted stairs. (Tool varies per
model)
C. Wand is used to give extra length to your hose.
Use it with any of the above tools.
D. Crevice Tool may be used in tight spaces,
corners and along edges in such places as dresser
drawers, upholstered furniture, stairs and baseboards.

attach wand and tools

3.3
7 Actual model may vary from images shown.
3.3 To attach tool or
wand to hose, push
firmly into place.
!
WARNING
Unplug vacuum before
connecting Powered
Hand Tool.