Filter Bag - Hoover UH30300 Guide D'utilisation

filter baG:

when to replace
Check filter bag from time to time. It is recommended
that you change the filter bag when dirt reaches the
dotted line. If more dirt than this accumulates, your
cleaner will not operate effectively.
IMPORTANT
All new carpet has loose fibers which can fill the
bag quickly while vacuuming. This type of
debris does not activate the "Check bag"
indicator available on some models.
what to buy: filter bag
Use only genuine HOOVER
vacuum. When purchasing a new bag, ask for
HOOVER ® HEPA
#902419001 or Carbon HEPA Type Y Bag
Part #902481001.
filter baG:
how to replace
CAUTION
!
To reduce the risk of injury from moving parts,
unplug vacuum before servicing.
Do not use vacuum without filter bag in place.
4.1 To change filter bag, push up door release latch
with thumb and pull handle forward. Remove door.
4.2 Push on the red lever over a trash receptacle
and drop the bag into the trash.
IMPORTANT
Do not clean out old filter bag and reuse.
Discard used filter bag.
4.3 Hold new filter bag as shown. Slide the
cardboard sleeve into the bag holder until the bag
is securely in place.
4.4 Fold bottom of bag and tuck between ribs (A)
on bottom door. Make sure bag does not interfere
with door seal.
4.5 Reposition bag door by placing tabs on bottom
of door into opening (B). Make sure the filter bag is
securely tucked into the vacuum.
Push door handle to snap securely shut.
® bags with your
Type Y Bag Part
!
CAUTION
!
Very fine materials, such as face powder or
cornstarch, may seal the filter bag and may
cause it to burst even though it is partially full of
dirt. When the cleaner is used to remove
material of this nature, change filter bag often.
4.1
4.3
4.5
b
9 Actual model may vary from images shown.
!
4.2
4.4
A