Stair Cleaning; How To Clean Tools; Check Bag Indicator; Maintenance - Hoover UH30300 Guide D'utilisation

stair cleaninG

3.4 Lift vacuum by Stair Cleaning Handle and
position on stairs. Clean forward to back. Never
leave the vacuum standing on stairs when not
cleaning.
3.5 Use the Hose and Powered Hand Tool
(Tool varies per model) for stair cleaning. When
using tools, always turn the brushroll off by stepping
on the "Suction Only Mode" (available on select
models only) pedal as shown in diagram 2.3.
Use extra care when cleaning on stairs. To avoid personal injury or damage, and to prevent the
cleaner from falling, always place cleaner at bottom of stairs on floor. Do not place cleaner on stairs or
furniture, as it may result in injury or damage. When using tools, always turn the brushroll off by
stepping on the "Suction Only Mode" (available on select models only) pedal as shown in diagram 2.3.

how to clean tools

To clean Hose and Powered Hand Tool, wipe with a damp cloth. DO NOT submerge in water.
Other cleaning tools may be washed in warm water with a detergent. Rinse and air dry completely
before using.

check baG indicator

The indicator (L) will begin to show red as the filter bag fills with dirt. There are
three conditions that will cause the indicator to become completely red:
1. If the bag is full; change the bag.
2. If very fine materials have been picked up, clogging the bag pores; change
the bag.
3. If there is a blockage in the nozzle, hose, tools or at the bag opening;
remove the blockage.
Familiarize yourself with these home maintenance tasks as proper use and care of your vacuum will ensure
continued cleaning effectiveness.
Any other servicing should be done by an authorized service representative.
A Thermal Protector has been designed into your cleaner to protect it from overheating. When the
thermal protector activates the cleaner will stop running.
If this happens proceed as follows:
1. Turn cleaner OFF and unplug it from the electrical outlet.
2. Replace Filter Bag.
3. Inspect and remove blockage along the dirt path. This blockage may occur at the: nozzle inlet,
hose connector, hose, bag opening inlet, secondary filter and final filter.
4. When cleaner is unplugged and motor cools for 30 minutes, the thermal protector will deactivate
and cleaning may continue.
If the thermal protector continues to activate after following the above steps, your cleaner
needs servicing.
Actual model may vary from images shown.
3.4
CAUTION
!

4. Maintenance

NOTICE
!
8
3.5
!
3.6
L
!