Silverline DIY Série Traduction Des Instructions Originales page 8

GB
Troubleshooting
Problem
No function when ON/OFF
Switch (6) is operated
Slow material removal
Scratches on workpiece
after sanding
Burn marks on workpiece
Excessive dust emission
8
Possible cause
No power
Defective ON/OFF Switch
Sanding sheet too fine or worn
Sanding sheet too coarse
Not enough material removed
Sanding sheet incompatible with material
Too much pressure exerted on to the sander
Dust extraction not working; sanding sheet
not aligned with dust extraction holes in the
Sanding Base Plate (4); extraction holes blocked
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Solution
Check power supply
Have the ON/OFF Switch replaced by an authorised Silverline service centre
Fit new sanding sheet with coarser grit
Fit new sanding sheet with finer grit
Continue sanding
Fit correct sanding sheet
Use less pressure whilst using the machine
Realign sanding sheet; unblock dust extraction holes