Virutex AS93 Mode D'emploi page 4

8. GARANTÍA
Todas las máquinas electroportátiles VIRUTEX, tie-
nen una garantía válida de 12 meses a partir del
día de su suministro, quedando excluidas todas las
manipulaciones o daños ocasionados por manejos
inadecuados o por desgaste natural de la máquina.
Para cualquier reparación dirigirse a un servicio oficial
de asistencia VIRUTEX, S.A.
VIRUTEX se reserva el derecho de modificar sus
productos sin previo aviso.
E N G L I S H
AS93 TRIMMER
1. TECHNICAL SPECIFICATIONS
Power.....................................................1,100 W
Universal motor......................................50/60 Hz
No-load speed...................................23,000 rpm
Standard chuck diam...................................6 mm
Acoustic pressure of continuous
emission equivalent to weighting A.........90 dB (A)
Acoustic power....................................103 dB (A)
Normal vibration rating (hand-arm)........2.6 m/s
Weight.......................................................3.7 kg
2. SAFETY INSTRUCTIONS FOR
USING THE MACHINE
Before using the trimmer, read care-
fully the GENERAL SAFETY INSTRUC-
TIONS LEAFLET enclosed with the
machine's documentation.
Use only bits with shank diameter suitable for the
chuck to be used and the trimmer speed.
Before working on the trimmer itself (change of tools,
brushes, etc) move the switch to the OFF position and
disconnect from the mains power supply.
Before fitting the bit, check that it is perfectly
secured in the chuck. After use, do not release
the machine from its grips until the bit has come
completely to rest.
The VIRUTEX range bit specifications are specially
designed for the features of this trimmer. It is there-
fore best to use bits from the wide range available
from VIRUTEX, or ones whose specifications comply
with those of VIRUTEX.
4
3. OPERATING INSTRUCTIONS
Electrical connection
The power supply voltage must coincide with the
details shown on the specifications plate.
Fitting the bit
Insert into slot A (Fig. 2) the key included with the
set of spanners for locking rotation of the shaft. The
spanner is used to loosen nut B. Fit the required bit
into the chuck and carry out the same operation in
reverse order.
4. MILLING HEAD OPERATING
INSTRUCTIONS
Fitting the head and adjusting bit outlet
Insert the head into the machine as shown in the
figure (Fig. 2). Turn the lock nut C until it is in the
position which gives the right measurement for the
bit and then tighten it down using the knob.
Setting the support guide and milling height
Unlocking the knob E (Fig. 3) allows the necessary
support guide height to be set using knob F. Once
set, relock with knob E.
5. MAINTENANCE
Brushes and commutator
2
It is important to change the brushes when they
reach a minimum length of 5 mm. Unscrew the black
plug from the housing and remove the guide carbon
brushes. Replace the carbon brushes with original
VIRUTEX brushes and check that they slide smoothly
inside their guides. Screw on the plug which encloses
them and leave the machine running for some 15
minutes. If the commutator shows scorching or
roughness, it is advisable to have it repaired by a
VIRUTEX technical service centre.
Never use emery paper for this operation.
6. OPTIONAL ACCESSORIES
1/4" diam. chuck
8 mm diam. chuck
Head for fitting hinges with template
CPN-66
PL 11 dove tailing template
7. NOISE AND VIBRATION LEVEL
The noise and vibration levels of this electrical device
have been measured according to the European
standard EN50144.
The noise level in the workplace can exceed 85 dB(A),
in which case it is necessary for the user to take noise
Ref.6727020
Ref.6027056
Ref.6650088
Ref.5000000