Radio Operation - Furrion DV3300S-BL Manuel D'instructions

Operation
Select a preset EQ mode
Press EQ on the remote control directly
(or push the VOLUME -/+ knob on the front
panel to active EQ mode, and then rotate
the VOLUME -/+ knob) to select EQ, CINEMA,
ROCK, CLASSIC, or FLAT.
The sound effect will change accordingly.
Turn on / off LOUD mode
Press and hold LOUD on the remote control
to turn on / off LOUD mode.
Adjust the sound equalizer curves
1. Press SEL on the remote control once
or more to select a sound equalizer
curve: VOL, BAS (without preset EQ), TRE
(without preset EQ), BAL, or BEEP (ON/
OFF).
2. Rotate the VOLUME -/+ knob on the front
panel (or press +/- on the remote control)
to adjust the level.
Select ZONE 1 / 2
Press ZONE 1 or 2 to turn on or off the audio
source in each of the different areas where
your speakers are connected.
"ZONE <1 >" or "ZONE <2>" will display on
the LCD once selected.
Return to the previous menu
Press or TITLE on the remote control.
Reset the unit
In case of incorrect display, button failure, or
distorted sound, you can press RESET with a
sharp object such as a clip to reset the unit and
load its factory default settings.

Radio Operation

Select a radio region
In radio mode, press and hold
19
seconds to select your desired radio region:
EUROPE, USA1, USA2, or AUSTRALIA.
Select AM/FM band
In radio mode, press and hold
front panel (or press AM/FM on the remote
control) once or more to select your desired
radio band: FM1, FM2, FM3, AM1, or AM2.
The selected band will be displayed on the
front panel.
Tune to / search for radio stations
In radio mode:
Press and hold
panel (or
control) to automatically search down/up
for an available station from the current
frequency.
Press
(or
to manually search up or down for
your desired station from the current
frequency.
Use the
In radio mode:
1. Press and hold
APS on the remote control) to search
for radio frequencies with sufficient
signal strength (starting from the lowest
frequency and ending until the search
cycle is finished).
Then the 6 strongest stations are preset
to the memory bank of the corresponding
preset number. The AS operation is
implemented in each bank of the selected
band. When the AS operation is finished,
radio broadcast will resume on M1. (A total
of 3x6 stations for FM and 2x6 stations for
AM can be stored.)
2. Press
remote control) to search for each preset
radio station starting from M1. When the
field strength level is above the threshold
for about 5
of the stop level, the radio holds at that
/ on the front
/ on the remote
/ on the front panel
/ on the remote control)
/ APS button
on the front panel (or
on the front panel (or APS on the
on the