Maintenance Schedule - Benchmark 196cc Manuel De L'utilisateur

Tilling tips:
The key to successful tilling is to begin with a shallow cut on the
first pass, and then work an inch or two deeper on each succes-
sive pass.
• Tilling depth will vary with ground conditions.
• When beginning to till in unbroken ground or in extremely
hard soil, set the lockpin in the highest hole of the drag
stake (SEE OPERATION SECTION). This will allow for shallow
tilling. With the drag stake in this position, make several light
passes over the area to be tilled. Reset for deeper depths
with successive passes.
• If tiller jumps or skids uncontrollably, lower the drag stake
by placing the lockpin in a higher hole. This will allow for
shallower tilling. Hold firmly to the handlebars to control
sudden lurches.
Cultivating tips:
If you plan to use your tiller for cultivating:
• Plant rows on 20" - 22" centers for ease of turning.
• Set the depth regulator lever with the lock pin in one of the
higher holes. This will allow for shallow cultivation neces-
sary to turn over weeds, and break up and aerate the soil.
MAINTENANCE

MAINTENANCE SCHEDULE

Your rototiller has been designed and produced by the industry's
leading manufacturer of outdoor power equipment to provide you
years of reliable operation.
Keeping your tiller in top running condition will prolong its life,
and help you obtain optimum performance.
Please read this normal care schedule, and note the recommended
care operating intervals to extend the life of your unit.
Good maintenance is essential for safe, economical, and
trouble-free operation. Keeping your tiller in top running
condition will prolong its life, and help you obtain optimum
performance. It will also help reduce air pollution. To help
you properly care for your engine, the following pages include
a maintenance schedule, routine inspection procedures, and
simple maintenance procedures using basic hand tools. Other
service tasks that are more difficult, or require special tools, are
best handled by professionals and are normally performed by a
technician or other qualified mechanic.
16 Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
WARNING
ENGINE AND SURROUNDING PARTS BECOME EXTREMELY
HOT DURING NORMAL USE. TEMPERATURE OF MUFFLER
AND NEARBY AREAS MAY EXCEED 150° F. THESE AREAS
WILL CAUSE SERIOUS BURN INJURIES IF TOUCHED BEFORE
THE ENGINE HAS COOLED.
WARNING
TO PREVENT ACCIDENTAL STARTING
THE ENGINE MUST BE TURNED OFF
AND COOL, AND SPARK PLUG WIRE
MUST BE REMOVED AND SECURED
FROM SPARK PLUG BEFORE CHECKING
AND ADJUSTING ENGINE OR
EQUIPMENT.
Maintenance, replacement or repair of the emissions control
devices and systems may be performed by any non-road
engine repair establishment or individuals. However, items must
be serviced by a service center to obtain "no charge" emissions
control warranty service. View all Repair Centers in your area by
using our location finder:
www.ardisam.com
The maintenance schedule applies to normal operating condi-
tions. If you operate your tiller under unusual conditions, such as
sustained high-load or high-temperature operation, or use in un-
usually wet or dusty conditions, consult your servicing dealer for
recommendations applicable to your individual needs and use.
NOTE: For engine maintenance, please refer to the manual
included with your product.
Maintenance Operation
Change forward belt
Check tiller transmission grease
Lubrication
Clean tine axle shaft
Lubricate wheel axle shaft
Owner's Manual
196cc REAR TINE TILLER
38247 (5140-005)
SPARK
PLUG
WIRE
50 hours
Before
Page or Every
Each Use
Season
17 X
18 X
19 X
19 X
-- X