Benchmark 196cc Manuel De L'utilisateur page 11

6. Locate the handlebar extensions and place them on the
outside of the lower handlebar mount. Be sure to line up the
handlebar extension pieces with the lower handlebar mount
as shown on the decal located on the lower handlebar mount
next to the mounting location. SEE FIGURE 3.
7. Insert one (A) M10 x 45 mm bolt into each of the lower
holes in the side of the extension pieces. The bolts will pass
through the lower hole of the lower handle bar mount. Place
a (D) M10 flat washer and a (C) M10 nylock nut onto the end
of each bolt and hand-tighten. SEE FIGURE 3.
8. Assemble the handlebar to the outside of the handlebar
extension (side opposite the lower handlebar mount). Insert
one (A) M10 x 45 mm bolt into each of the lower holes in the
handlebar and through the middle hole on the handlebar
extension. Place a (D) M10 flat washer and a (C) M10 nylock
nut onto the end of each bolt and hand-tighten. SEE FIGURE 3.
9. Insert one (B) M10 x 25 mm bolt into each top hole on the
handlebar and through the middle hole on the handlebar
extension. Place a (D) M10 flat washer and a (C) M10 nylock
nut onto the end of each bolt and hand-tighten. SEE FIGURE 3.
10. Tighten all M10 bolts and nuts that were assembled in the
"Attach the Handlebar" section.
Attach the Side Shields:
11. Locate the side shields and place one up against the side of
the tine guard and hold in place. SEE FIGURE 4.
12. Place one (H) M6 flat washer onto one (F) M6 x 12 mm bolt.
Repeat this process for all three (F) M6 x 12 mm bolts. Insert
the three bolts into the three holes of the tine guard, making
sure they pass through the side shield as well. Place a (H)
M6 flat washer and a (G) M6 nylock nut onto the bottom of
each of the bolt/washer combinations and tighten all with a
wrench/socket.
NOTE: The side shield needs to be below the tine guard
when they are attached together.
13. Repeat steps 11-12 for the second side shield.
LOWER HANDLEBAR
Get parts online at www.ardisam.com or Call 800-345-6007 M-F 8-5 CST
HANDLEBAR
HANDLEBAR
B
EXTENSION
A
D
MOUNT
C
Owner's Manual
196cc REAR TINE TILLER
38247 (5140-005)
ADJUSTING KNOB
DRAG STAKE
LOCK PIN
FIGURE 2
A
FIGURE 3
TINE GUARD
SIDE SHIELD
FIGURE 4
11