emerio HV-111712 Mode D'emploi page 7

3. Plug in the appliance.
4. Press the on/off button to turn on the appliance. Press it again, the unit will be turned off.
NOTE: During use, please pay attention to the dust capacity and do not exceed the "MAX" level indicated on
the dust cup. This appliance is for dry suction only.
Caution: The suction hole opening must be open and free of any obstructions at all times. Otherwise, the
motor will overheat and could become damaged.
CLEANING AND MAINTENANCE
1. Except for the main unit, other parts can be cleaned in warm soapy water (<40℃). Rinse and dry them
completely before reassembly. Do not immerse the main unit in water or any other liquids.
2. Use only a soft moist cloth to clean the outside of the unit. Do not allow any kind of liquid to enter the unit.
3. Do not use aggressive chemicals or abrasives.
4. Do not use the device if the filter is broken or worn out.
5. The unit does not contain parts serviceable by you, do not disassemble it and do not try to repair it
yourself.
In order to achieve the best performance, empty the dust cup and clean the dust cup filter after each use.
1. Press the dust cup release button to remove the container from the main unit.
2. Press down the locking clip on low end of the dust cup to empty dust from the container.
3. Detach the upper part from the dust cup. Gently pull the dust cup filter (A) and cyclonic frame (B) out of the
dust cup. Rinse them in warm water, and then air dry completely for 24 hours before placing them back in
the dust cup.
Important Note: DO NOT use a washing machine to clean the dust cup filter. Do not use a hair dryer to dry it.
AIR DRY ONLY.
- 6 -