Table des Matières
Publicité
1. Safety information
EN
For your safety and correct
operation of the appliance, read
this manual carefully before
installation and use. Always keep
these instructions with the
appliance even if you move or sell
it. Users must fully know the
operation and safety features of the
appliance.
The wire connection has to be
done by specialized technician.
• The manufacturer will not be held
liable for any damages resulting
from incorrect or improper
installation.
• The minimum safety distance
between the cooker top and the
extractor hood is 650 mm (some
models can be installed at a
lower height, please refer to the
paragraphs on working dimensions
and installation).
• If the instructions for installation
for the gas hob specify a greater
distance, this must be respected.
• Check that the mains voltage
corresponds to that indicated on
the rating plate fixed to the inside
of the hood.
• Means for disconnection must be
incorporated in the fixed wiring in
accordance with the wiring rules.
• For Class I appliances, check
that the domestic power supply
guarantees adequate earthing.
• Connect the extractor to the
exhaust flue through a pipe of
minimum diameter 120 mm. The
route of the flue must be as short
as possible.
• Regulations concerning the
discharge of air have to be fulfilled.
• Do not connect the extractor
hood to exhaust ducts carrying
combustion fumes (boilers,
fireplaces, etc.).
• If the extractor is used in
conjunction with non-electrical
appliances (e.g. gas burning
appliances), a sufficient degree of
aeration must be guaranteed in
the room in order to prevent the
backflow of exhaust gas. When the
cooker hood is used in conjunction
with appliances supplied with
energy other than electric, the
negative pressure in the room must
not exceed 0,04 mbar to prevent
fumes being drawn back into the
room by the cooker hood.
• The air must not be discharged into
a flue that is used for exhausting
fumes from appliances burning gas
or other fuels.
• If the supply cord is damaged,
it must be replaced from the
manufacturer or its service agent.
• Connect the plug to a socket
complying with current regulations,
located in an accessible place.
• With regards to the technical and
safety measures to be adopted for
fume discharging it is important
to closely follow the regulations
provided by the local authorities.
WarninG: Before installing
the Hood, remove the
3
Publicité
Table des Matières
