Checking The Flash's Remaining Battery Charge - Panasonic Lumix DMW-FL360 Manuel D'utilisation

Checking the Flash's
Remaining Battery
Charge
≥
Install the batteries and then turn
on the unit and check the battery
remaining power.
1 Press the [POWER] button.
≥
Charging now starts.
2 Check that the [TEST/
CHARGE] button lights.
≥
After the batteries have been fully
charged, the [TEST/CHARGE]
button lights.
14
VQT1B11
POWER
TEST/CHARGE
≥
If it takes as long for the [TEST/
CHARGE] button to light as the
period indicated in the table below,
it means that the batteries are
nearly worn out. Replace them
with fresh batteries as soon as
possible.
Alkaline batteries
Rechargeable nickel
metal hydride
batteries
≥
If the [TEST/CHARGE] button and
[AUTO CHECK] lamp both flash at
the same time, it means that the
batteries are almost completely
worn out and should be replaced
with fresh batteries as soon as
possible.
3 Press the [POWER] button
to turn off the unit's power.
≥
When the [TEST/CHARGE] button
is pressed, the unit may fire.
≥
Turn off the power in the following
situations:
≥
When mounting the unit onto, or
disengaging it from, the digital
camera
≥
When you do not want the unit
to fire
≥
When you are not going to use
the unit
More
than 30 s
More
than 10 s