Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• STARTING A COOKING ZONE
- Press the selection button of
the required cooking zone. In
the display zone, the control
LED is on steady. It shows that
the zone is live.
- Press the - or + button to select a heat level between 1 and
9. Hold down the + or - button and the heat level increases
or decreases gradually.
The following examples are for information only. Personal
experience should then let you adapt these settings to your taste
and habits.
0
:
Off
1
:
)
2
:
) ..... Melting heat
3
:
Keeping hot
4
:
Heating up
5
:
Thawing, stewing, full cooking, low temperature
cooking
6
:
Cooking without lid
7
:
Frying, meat browning and roasting
8
:
High temperature cooking and roasting, seizing
9
:
Frying, boiling large quantities of water.......
• STOPPING A COOKING ZONE
- Press the selection button of the required cooking zone.
- Press the "-" button to display heat level "0". Now the zone goes
off, the indicator "0" goes off after 10 seconds.
- To stop rapidly, press the - and + buttons at the same time.
The heat level automatically goes down to "0". The cooking zone
goes off.
• GENERAL STOP
The cooking zones and the timer can be stopped at any
moment by pressing the On-Off button.
• RESIDUAL HEAT INDICATOR
The control panel tells the user when the surface temperature of
the cooking zones exceeds about 60°C, by the following displaying:
"H". When the temperature goes back below 60°C, the "H"
display goes off.
For ending the cooking, we advise switching off the cooking zone
and using the residual heat of the zone to finish cooking gently.
N.B. After a cut in the current, the residual heat indicator disappears
completely, even if the surface temperature exceeds 60°C.
• OPERATING THE ADDITIONAL COOKING ZONE
(TWO ZONES)
The cooking zone with two zones is fitted certain models.
To activate the additional cooking zone :
- Press on the additional cooking zone button
The corresponding control led for the additional cooking zone
is active.
To desactivate the additional cooking zone :
- Press on the additional cooking zone button
The corresponding control led for the additional cooking zone
goes off when it is desactivated.
• OPERATING THE ADDITIONAL COOKING ZONE
(THREE ZONES)
A triple circuit cooking zone is fitted on one model.
- Press on the cooking zone button, the central cooking zone is
activated.
To activate the first additional cooking zone :
- Press on the additional cooking zone button
led corresponding comes on.
To activate the second additional cooking zone :
- Press again on the additional cooking zone button
second control led corresponding comes on.
To deactivate one or the two additionnal cooking zones, press
once time or two times on the additional cooking zone button.
The central cooking zone operates in standard mode, it switches
off normally.
• OPERATING THE 3200 W COOKING ZONE
- Press on the button of this cooking zone.
The first touch activates the standard cooking zone 2100 W,
adjustable from 0 to 9.
To operate the 3200 W cooking zone (2100 W + 1100 W),
- Press on the cooking zone button, press the "+" button until the
level "9", release the button briefly and press it again, the second
cooking zone 1100 W comes on and completes the first. The
indication "P" comes on.
- To stop the additional cooking zone, press the button "-", the
indication "P" goes off, and the cooking zone is functionning in
standard mode.
This cooking is not supplied with the fast heater operation.
• PROGRAMMING A COOKING ZONE
Every cooking zone can be programmed for a maximum time of
99 minutes.
- Start the required zone.
The control LED near the heat level must be displayed, it shows
that the zone is live.
- Press the Timer button
The zone mark around the timer display shows the controlled
zone.
- Press again on the timer button to select a time in minutes
between 0 and 99 minutes or press on the "-" button to decrease
the time between 60 minutes and 0.
the programmed time can be modified at any moment reactivating
the cooking zone and then the timer button.
When the time is run, the cooking zone goes off automatically and
an audible beep sounds for 1 minute, press the timer button to
stop it.
the time can be used alone as reminder, it will ring at the end of
the programmed time.
• LOCKING BUTTON OPERATION
The locking function holds the current settings, or prevents anyone
from starting the hob. It is also useful for cleaning the control strip
as the controls can be locked without the cooking zones being
on.
. Press the On/off button.
.
. According to your choice, start or not the cooking zones.
. Press the locking button to set the data ; in this way no other
button works, except the On/Off button. The locking indicator lamp
comes on.
.
To release the locking function, just press the locking button ;
the indicator lamp goes off, all the controls work again.
If when the controls are locked, the timer is on, the time will be
counted automatically and the zone switched off at the end of the
programmed time.
If the locking control is on when the hob is finally shut down, the
locking control stays operational and prevents any action when
the hob is restarted. Press the locking button to unlock.
10 GB
. The control
. The
.
Publicité
Table des Matières
