connected to the mains
switched on or off) is up to 6 hours* (*chapt. 10).
The charging circuit for the battery is controlled electronically: There is no danger of overloading
the battery. You can leave the mains adapter continuously connected.
If you are not using the baby monitor for a long period of time: Disconnect the mains
adapter from the wall socket. Remove batteries to avoid damage due to battery leakage.
10
3.2
BABY UNIT
The baby unit may be powered by mains using the mains adapter with the thick plug (fig. 9) or
by batteries. When using the batteries the baby unit is mobile.
3.2.1
Mains Adapter
Installation of the mains adapter with the thick plug
1. Connect the mains adapter with the thick plug to the jack on the right-hand side of the
baby unit (chapt. 1.4 14 ).
2. Plug the mains adapter into a wall socket.
For your own safety comply with the above described installation order. Disconnect the unit vice
versa: First disconnect the mains adapter from the wall socket and then from the unit.
Only use the supplied mains adapter.
11
Incorrect adapter types can cause damage to the unit. Before using the mains adapter, check if
it is damaged or if there are uninsulated cables. Replace the mains adapter if any damage is
found (chapt. 8.3 ).
Never use a damaged mains adapter.
12
Before connecting the mains adapter: Make sure the voltage shown on the nameplate of
the mains adapter corresponds to the local mains power.
13
3.2.2
Batteries
In the baby unit batteries may be installed with the following specifications:
•
Type: AA (R6)
•
Material: high quality alkaline
•
Output: 1.5 V
•
Quantity: 4 pieces
The batteries are not included in the pack. It is possible to insert rechargeable batteries,
but since the baby unit is not equipped with a charging device, rechargeable batteries
must be charged in an external battery charger when empty.
Note
Use the mains adapter when mains is available.
When the green light of the battery indicator (chapt. 1.4) flashes, the baby unit will switch
Note
off in approximately 30 seconds* (*chapt. 10).
Installation of batteries (fig.7):
1. Unlock the battery cover of the baby unit by placing a flat, blunt object in the slot on
the bottom of the baby unit.
the charging time for the parent unit battery (whether the parent unit is
(for specification see chapt.
38
10):