ResMed AirFit N20 Mode D'emploi page 11

Reassembly
1. Push the cushion into the frame. The frame has a shape that allows
you to insert the cushion only one way.
2. With the ResMed logo on the headgear facing outside and upright,
thread the upper headgear straps into the frame slots from the inside.
Fold them over to secure.
Cleaning your mask at home
It is important to follow the steps below to get the best performance out
of your mask.
WARNING
• As part of good hygiene, always follow cleaning instructions and
use a mild liquid detergent. Some cleaning products may damage
the mask, its parts and their function, or leave harmful residual
vapours that could be inhaled if not rinsed thoroughly.
• Regularly clean your mask and its components to maintain the
quality of your mask and to prevent the growth of germs that can
adversely affect your health.
CAUTION
If any visible deterioration of a system component is apparent
(cracking, crazing, tears etc), the component should be discarded and
replaced.
Daily/After each use:
Before cleaning, take the mask components apart according to the
disassembly instructions.
1. Soak and agitate the cushion, multi-hole elbow and short tube in warm
water (approximately 30°C) using a mild liquid detergent for up to
10 minutes.
2. Clean the components with a soft bristle brush, paying particular
attention to the small vent holes on the multi-hole elbow.
3. Thoroughly rinse the components under warm flowing drinking quality
water.
English 5