Setup; Settings; Bluetooth Settings; Sound Settings - JVC KD-X561DBT Mode D'emploi

Setup

Setup

Settings

1
Press and hold <
2
Press <E>/<F> to select the category.
3
Turn the volume knob to select an item (see the
following table), then press the knob.
4
Repeat step 3 until the desired item is selected/
activated or follow the instructions stated on
the selected item.
5
Press < >.
Audio Settings
Fader R12 — F12 (00): Adjusts the front and
rear speaker output balance.
Balance L12 — R12 (00): Adjusts the left and
right speaker output balance.
General Settings
Beep ON/OFF: Activates or deactivates the
keypress tone. Default is "ON".
Date/Clock Adjusts the date and clock. (P.3)
Language Selects the text language used for on-
screen information.
Time 12h/24h: Selects time format. Default
Format
is "24h".
Wallpaper Black/Blue: Selects the wallpaper
image.
Demo
Set the demonstration mode. Default
is "ON".
Initialize Select [Initialize] and then select [Yes]
to set all the settings to the initial
default settings.

Bluetooth Settings

Sync
ON/OFF: Activates or deactivates the
Phonebook
synchronization of the phonebook
in the connected smartphone with
the unit.
BT
Displays the information about the
Information
connected Bluetooth device (device
name, phone name, and mac address).
> to display the settings.

Sound settings

1
Press < > to display the sound setting.
2
Turn the volume knob to select an item (see the
following table), then press the knob.
3
Repeat step 2 until the desired item is selected/
activated or follow the instructions stated on
the selected item.
4
Press < >.
Graphic
Selects a preset equalizer suitable to the
Equalizer
music genre.
Flat / DRVN / Hard Rock / Hip Hop / Jazz
/ Pop/ R & B / User / Classical
Select [User] to use the settings made
1) Press the volume knob to select the
frequency.
2) Turn the volume knob to adjust the
level.
3) Press <
Loudness
Sets the amounts of boost of low and
high tones.
"ON", "OFF" (Default)
X'over
You can set the crossover frequency of
speakers.
1) Press <E>/<F> to select the
speaker.
2) Press the volume knob to select the
item.
3) Turn the volume knob to adjust the
value.
4) Press <
Delay
Adjust the sound delay time so that the
sounds from different speakers arrive at
the listener sitting on the selected seat
at the same time.
1) Press <E>/<F> to select the
speaker.
2) Turn the volume knob to adjust the
value.
3) Press <
>.
>.
>.
English |
9