Niko 05-711 Mode D'emploi page 64

05-711
the procedure to reactivate the memory function. This function and
the last set light level are stored in a non-volatile memory, so they will
not be lost in the event of a power failure. With memory function, the
dimmer first switches on at the min. light level. Thereafter the dimmer
switches on at the last set value.
With memory
- Press briefly = switching on/off, 'on' at previous level
- Press long = dimming up/down
- Press long when dimmer is 'off' = dimmer dims up from 0%
- When dimming up: dimmer stops at maximum value.
(Note: Do not press max. for more than 10s so that the control does not
switch to 1-button operation without memory function.)
- When dimming down: dimmer stops 2s at min. and then dims up. A
renewed (long) press reverses the dimming direction.
Without memory
If you briefly press the button when the dimmer is 'off', the dimmer
is always switched on at maximum value. The other operations are
identical to those 'with memory'.
Operation of input 2 (connection terminals, COM terminal and terminal
2):
Input 2 can be used to save and retrieve a light atmosphere. The light
atmosphere is set by default to max. light level.
To save a light atmosphere, proceed as follows:
1. Set the desired light intensity with input 1.
64 EN