Information About This Operating Manual; Safety Information; Electrical Connection; Safe Operation - Oase FiltoMatic CWS 7000 Notice D'emploi

1

Information about this operating manual

Welcome to OASE Living Water. You made a good choice with the purchase of this product FiltoMatic
CWS .
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself
with the unit. Ensure that all work on and with this unit is only carried out in accordance with these
instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on
to a new owner.
2

Safety information

2.1

Electrical connection

► Electrical installations must meet the national regulations and may only be carried out by a qualified
electrician.
► A person is regarded as a qualified electrician if, due to his/her vocational education, knowledge and
experience, he or she is capable of and authorised to judge and carry out the work commissioned to
him/her. This also includes the recognition of possible hazards and the adherence to the pertinent
regional and national standards, rules and regulations.
► For your own safety, please consult a qualified electrician.
► The device may only be connected if the electrical data of the device and the power supply coincide.
The device data is to be found on the device type plate, on the packaging or in this manual.
► Only connect the unit to a correctly fitted socket.
► Extension cables and power distributors (e.g. outlet strips) must be suitable for outdoor use (splash-
proof).
► Protect the plug connection from moisture.
2.2

Safe operation

► Only operate the FiltoMatic CWS if no persons are in the water.
► Never carry or pull the UVC clarifying unit and the dirty water pump of the FiltoMatic CWS by holding
on the connection cables.
► Do not operate defective units. Do not operate the FiltoMatic CWS if the electrical connection cables
are defective. Pull the power plug immediately. The connection cables of the UVC clarifying unit and
of the dirty water pump cannot be repaired. Replace the components. Dispose of the defective
components in compliance with the environmental regulations.
► Never open the housing of the UVC clarifying unit, dirty water pump, control system or their attendant
components, unless this is explicitly mentioned in these instructions of use.
► Only use original spare parts and accessories.
► Never use the system for filtering fluids other than water.
► The radiation of the UVC lamp, even in small doses, is dangerous for eyes and skin. Never operate
the UVC lamp in a defective housing or outside of the housing.
► Never operate the UVC lamp without cleaning rotor, as this also acts as an eye protection against
UVC radiation.
► Overvoltage in the mains could lead to operating malfunctions of the unit. For information, please refer
to chapter "Remedy of faults".
- EN -
25