Microsoft Surface Hub de 55 po Guide D'assemblage page 8

B. Attach the display mount to the column.
a. Fit the center hole at the top of the display mount over the alignment pin at the top of the column.
b. Make sure the screw holes on the display mount align with the screw holes on the column. Insert the column screws into the holes and loosely tighten them with a hex key.
c. Once you've put in all the screws, tighten them fully. Do not over tighten.
tooltip tooltip tooltip tooltip
Step 2: Attach the mounting pucks and hang the Surface Hub on the rolling stand
A. On the back of the Surface Hub, identify the mounting screw holes.
B. Use the 20mm puck screws to attach the mounting pucks to the back of the Surface Hub.
C. Tighten the screws fully. Do not overtighten.
Note: Before you lift the Surface Hub, make sure the wheels of the base are still blocked.
D. Hang the Surface Hub on the display mount.
a. Lift the Surface Hub with its back facing the display mount, and align the mounting pucks with the slots on the display mount.
b. GENTLY lower the Surface Hub until the mounting pucks are securely seated in the slots.
c. Once the pucks are seated, the Surface Hub will be supported by the rolling stand.
E. Thread the 35mm securing screws into the mounting holes at the base of the Surface Hub, below the mounting pucks, and tighten them fully with a hex key. Do not over tighten.
6
K