Assembly And Mounting Instructions - Microsoft Surface Hub de 55 po Guide D'assemblage

Assembly and mounting instructions

Step 1: Assemble the stand
A. Connect the base to the column.
a. Remove column door and set aside.
b. Place the base with its wheels on the floor, and block the wheels to keep the stand from moving while you assemble it.
c. Fit the alignment holes on the bottom of the column over the alignment pins at the center of the base.
Note: From this point, hold the column in place until the column is secure.
d. Slide the column studs through the holes in the bottom of the column and through the base.
e. Loosely thread column nuts onto the column studs from underneath.
f. Once you have put nuts on all of the column studs, fully tighten all of the nuts.
Note: Do not over tighten the nuts.
K
5