Important - Microsoft Surface Hub de 55 po Guide D'assemblage

Explanation of safety symbols to reduce tip-over risk
Model
This guide outlines the steps for assembling the Surface Hub 55" and Surface Hub 84" rolling stand. These stands require two people to assemble. Before beginning, make sure you have all of the components in the parts list.
IMPORTANT: Avoid damage to your device.
vertical. The Surface Hub 84" is intended to be supported only by the lifting handles when not supported by the mounting system. Do not place either device on its face, back, top, or sides.
Specifications
Model Device Stand
weight weight
Surface Hub 55" 105 lb. 270 lb.
Surface Hub 84" 250 lb. 270 lb.
Required tools (not included)
#2 Phillips screwdriver
5mm hex key (55" only)
6mm hex key (84" only)
Torque Wrench with 5mm and 6mm hex bits
13mm socket
Scissors
Meaning
Do not allow children under 16 to move the stand. Only adults should move the stand. Move the stand slowly.
Use only the handles to move this unit. Push on the narrow side, not on the front.
Push near the middle. Never apply force at the top.
Push, don't pull.
The Surface Hub 55" is intended to be supported only by its bottom edge when not supported by the mounting system. Rest it only on its bottom edge, and support it to keep it
Handle Designated load
weight capacity
NA 375 lb.
30 lb. 550 lb.
K
PMS
185 C
3