NAD HTR 3 Manuel D'installation page 9

CHECKING CODE-LIBRARY NUMBER
You can check the current code-library on any DEVICE
SELECTOR key as follows. Enter Library Mode by simultaneously
pressing-and-holding for 3 seconds both the desired
component's DEVICE SELECTOR key and the [AVPS] key, until
the Learn LED turns green. Press the [DISP] key; the HTR 3
indicates the current code-library by flashing its [CUSTOM],
[VCR], and [MACRO] keys.
For example, to indicate code-library #501, the HTR 3 will flash
[CUSTOM] 5 times, pause, and then flash [MACRO] once. You might
wish to make a note of your components' code-library numbers.
SUMMARY OF THE HTR 3 MODES
R3_eng_OM_v02.indd 9
Mode
Learn/Copy/Punch Through
Delete Mode
Macro Record
Library Mode
Back Light Timeout
Factory Reset
Keys To Press (for 3 seconds)
Device Key + RES Key
Device Key + RTN Key
Macro Key + Function Key
Device Key + AVPS Key
DISP Key + Digit Key
See "Factory Reset" above

7/8/07 22:03:27