Search Mode - NAD HTR 3 Manuel D'installation

R3_eng_OM_v02.indd 8
When you enter the correct number the component will turn
off; press [ENTER] to accept that code library number and exit
the Library Mode.
NAD-brand component
CD Player (new)
CD Player (old)
Tape Deck B
Tape Deck A
T562, T585, M55, T535
T550, L55
T512, T531, T532
T571, T572
L56
T513, T514, T533, T534
Zone Remote - Zone 3
Zone Remote - Zone 4

SEARCH MODE

If none of the codes from the table, when entered, turns on the
component, and if you are quite sure you have followed the
above procedure completely and carefully, you may want to
try the "search" method as follows:
Enter Library Mode by simultaneously pressing-and-holding
for 3 seconds both the desired DEVICE SELECTOR key and the
[AVPS] key, until the Learn LED turns green. Now press-and-
hold the HTR 3's
the available codes at a rate of approximately 1 per second.
When the component turns off, immediately release the cursor
key; press [ENTER] to accept that code-library and exit the
Library Mode. Try a few commands; should you prove to have
stepped past the needed code-library, re-enter the Library
Mode and use the cursor key to step back to it.
NOTE
It is possible that search mode will find code-libraries that
operate, at least partially, some other brand (non-NAD)
components. You may certainly exploit such capabilities
as you find them. However, since we can only ensure the
completeness or accuracy of NAD code-libraries, we cannot
support the HTR 3's operation with other-brand components.

HTR 3 code-library numbers
or key; the remote will step through all
200
201
400
401
600
601
602
602
604
605
3112
4112
7/8/07 22:03:27