Dea SPACE Notice D'emploi Et Avertissements page 39

3 Selection operating with or without encoder
1. Scroll down the parameters with
lise P029;
2. Access the parameter by pressing the
3. Acting on and keys, set:
- d001 = 1 channel encoder;
- d002 = 2 channel encoder;
4. Confirm your choice by pressing the
to P029).
4 Transmitters coding selection
1. Scroll down the parameters with
P027;
2. Confirm by pressing on the
3. Select the type of transmitter by scrolling
- d000=fix rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Confirm by pressing on the
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004) AFTER you have set the new encoding.
5 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire param-
eter (i.g. P032);
2. Confirm by pressing on the
3. By pressing on and , set up the desired value;
4. Confirm by pressing on the
previously selected).
For the complete list of the "Operating Parameters" See the table
on page. 45.
6 How to search and delete a transmitter
1. Scroll down the parameters until you visualize P006;
2. Confirm by pressing on the
3. By pressing on and , keys, select the transmitter you
want to delete (eg. );
4. When " " flashes, confirm the deletion by pressing
the key for a few seconds;
5. Release the key when appears "
6. The selected transmitter is deleted (display shows again
P006).
and keys until you visua-
key;
key (display returns again
and keys until you visualise
key;
and keys:
key (display shows again P027).
key;
key (display shows the parameters
key;
";
! IMPORTANT !
37