CyberPower CPS7500PRO Manuel D'utilisation page 10

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CPS7500PRO/CPS7500PIE
DEFINITIONS FOR ILLUMINATED LCD
Definitions for illuminated LCD
The LCD Display indicates a variety of EPS operational conditions. All descriptions apply when the EPS
is plugged into an AC outlet and turned on or when the EPS is on battery.
1. INPUT VOLTAGE Meter: This meter measures the AC voltage
that the EPS is receiving from the utility wall outlet. The EPS is
designed, through the use of automatic voltage regulation, to
continuously supply connected equipment with stable, 220
output voltages. In the event of a complete power loss, severe
brownout or over-voltage the EPS will rely on its
external battery
to supply consistent 220 output voltage. The Input Voltage Meter
can be used as a diagnostic tool to identify poor quality input
power.
2. OUTPUT VOLTAGE Meter: This meter measures, the AC
voltage that the EPS is providing to the equipments. It displays
normal line mode, AVR mode, and battery backup mode.
3. NORMAL MODE Icon: This icon will illuminate when the EPS is working under normal conditions.
4. ON BAT (On Battery) Icon: When a severe brownout or blackout, this icon illuminates and an alarm
sounds (2 short beeps followed by a pause) to indicate the EPS is operating from
its external batteries.
During a prolonged brownout or blackout, the alarm will sound continuously. When the BATTERY
CAPACITY Meter shows one 20% capacity segment remaining it indicates the EPS's external batteries
are nearly out of power. You should save files and shut down your equipment immediately.
5. AVR (Automatic Voltage Regulator) Icon: This icon will illuminate whenever your EPS is
automatically correcting high or low AC line voltage. This is a normal, automatic operation of your EPS,
and no action is required on your part.
6. SILENT MODE Icon: This icon illuminates whenever the EPS is in silent mode. The buzzer will not
beep during the battery mode until the battery reaches low capacity.
7. OVER LOAD Icon: This icon will illuminate and an alarm will sound to indicate the battery supplied
outlets are overloaded. To clear the overload, unplug some of your equipment from the battery supplied
outlets until the icon is no longer illuminated and the alarm stops.
8. FAULT MODE Icon: This icon illuminates if there is a problem with the EPS. Please contact
CyberPower Systems for further help and support.
9. BATTERY CAPACITY Meter: This meter displays the approximate charge level (in 20% increments) of
the EPS's external battery. During a blackout or severe brownout, the EPS will switch to battery power,
the ON BAT icon will be illuminated, and the charge level will decrease.
9
Copyright © 2011 CyberPower Systems, Inc.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cps7500pie

Table des Matières